Again, the shelves came with a little piece of nylon strap that you are supposed to screw into the wall with a single cheapo anchor, and that is supposed to be sufficient. Anyway, the forces as it begins to fall would be very small. Each large strip can handle about 5 pounds in shear, so I figure they can handle more tension perpendicular to the surface. Rock solid, and no vibration.Ĭommand strips are removable, even after years of use. You may not notice the damage, but as plaster comes loose from the lath, it will eventually begin to sag and soon fall off the wall if the sagging continues unchecked. So to control that, and to add an additional level of protection, I stuck a 2x4 to the wall using six large 3M Command adhesive strips, and then bolted the shelf uprights to the 2x4. IKEA Ivar, if you are interested.)īut like most things IKEA, these are made with the minimum structure required, and while they don’t lean or rack, they do bow from side to side a little. They cannot fall over, unless the sides collapse catastrophically (they are open, ladder-like assemblies predrilled for shelf supports. So the bookshelves are essentially wedged into place against the ceiling. With books filling the bookshelves, you can’t see the 1x2s. Then I tightened the adjustable feet to make sure it was tight. I just set them up then, screwed a piece of 1x2 to the side of each bookshelf close to the wall, snugged up tight to the ceiling. The bookshelves are floorstanding but quite tall, standing about 4 inches below the ceiling. I want to share my recent experience with anchoring a cabinet on a lath and plaster wall. In case it is helpful at all, I’ll post what I ended up doing. Reductive Anchors in lath and plaster walls: use metal toggle bolts. The only way there isn’t is if it’s solid concrete in which case that’s easy I’m probably not the only one who has struggled to mount a television on a wall, especially with old plaster. Even if it is solid plaster there should still be some structural element you could fasten to. The last portion, and my favorite when it comes to plaster and drywall, is how to hang heavy things on plaster walls and other weaker building materials. If you do need to anchor through whole wall you can put a wall mounted coat rack or shelf on the other side or hang a picture or painting over bolts. Just away from potential electrical or plumbing and limit drill depth to about an inch. (Or previous homeowner special who knows what.) 5" From floor Could Just Be Lots Of Debris In Wall cavity, I Would Suggest Going up higher, Maybe 3’ or at your actual height, And doing s series of small,Easily Patchable, Like 1/8"-1/4" Test holes in a pattern to Try And find lathe(if it’s plaster) Probably 3 Holes At 3/4-1" Apart vertically Also Maybe 1-2’ Over another Set. What Bit did you drill with? I Think A Standard Bit in a non-hammer Drill Would Have decent Resistance If It Was Solid Plaster. It does not store any personal data.I’m not the most experienced to comment since I’ve got limited regional and condo experience. The cookie is set by the GDPR Cookie Consent plugin and is used to store whether or not user has consented to the use of cookies. The cookie is used to store the user consent for the cookies in the category "Performance". This cookie is set by GDPR Cookie Consent plugin. The cookie is used to store the user consent for the cookies in the category "Other. The cookies is used to store the user consent for the cookies in the category "Necessary". The cookie is set by GDPR cookie consent to record the user consent for the cookies in the category "Functional". The cookie is used to store the user consent for the cookies in the category "Analytics". These cookies ensure basic functionalities and security features of the website, anonymously. Necessary cookies are absolutely essential for the website to function properly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |